Smart Home Automation Forum

Hello,

I have a A4S Controller and a 2 button glass momentry switch and a 6 button momentry switch. Can someone share a wiring diagram for both these switches onto the A4S. 

I connected the glass switch but the input was permantly on in HA and pessing the switch made no difference. If i could have a wiring digram for all terminals on the switches as a example that would be great.

can you take a photo how to wire. just let switch's KEY line to A4S' board digital input port. KCOM with GND.
here is diagram for KC868-A4, but A4S is similar:
https://www.kincony.com/forum/showthread.php?tid=2500

(05-08-2023, 12:52 AM)admin Wrote: [ -> ]can you take a photo how to wire.  just let switch's KEY line to A4S' board digital input port. KCOM with GND.
here is diagram for KC868-A4, but A4S is similar:
https://www.kincony.com/forum/showthread.php?tid=2500

Yes i wire that way amd it works but not using the DCOM, D1,D2 etc. Can you show a diagram how to connect that way so we can use the led state change.

D1,D2... if use for LED state feedback.
your A4S output port feedback +12v to D1,D2.... so that LED on switch panel will be ON.
if you want to test, you can connect D1,D2 with +12v, so that switch panel's LED will be ON.

Can these be wired in the same terminals as the com and K1? When I wired just dcom to gnd and input 1 the input stayed pemantly active.

If you have a drawing of both d1 and k1 connected that will be great

COM and GND is same point. it's connected internel on PCB.
this is sample diagram H32B with switch terminal board for wall switch panel: