Hi,
I interested in this product, but I want to ask about Power Factor correction. Is it realized, or just calculates power by formula P=U*I ??? Is it possible to assign clampts to different voltage inputs? Asking because if i have 3 pahase input, I need to assign current consumption to used input.
Power Factor need calculate by formula.
M16v2 have 3 channel voltage detect port, so it can monitor 3 phase power line, A, B, C. it's ok for you.
Question is: Is it possible to set CH1 current to B voltage? or Ch2 to A voltage, hope you understand
it just set by ESPHome, not MUST CH1 current need with X CH voltage
Ok, so only thing that missing on this device is power factor correction
M30 have power factor corrections?
no,it also need calculated by software.
So calculations not integrated to your firmware?