Smart Home Automation Forum

Hi everyone,
I’m looking for some advice on the KC868-A16 board. I want to know if it is compatible with a 433 MHz Superheterodyne RF module. Previously, I had issues with signal range using common 433 MHz RF modules, so I bought the Superheterodyne module to test it. However, when I tried using it with a 433 MHz alarm sensor, it didn’t detect the signal when I attempted to learn it using the KCS firmware.
I’m fairly new to this and just started experimenting with this board today. I also haven’t soldered the antenna to the RF module yet, but I was testing the sensor right next to the module.
Has anyone had experience with this setup or could offer any insights?
Thanks in advance!

[attachment=5786]

when you download firmware, need remove the RF receiver module.
if can't learn by KCS firmware, maybe your remote's data code not supportted.

(08-09-2024, 12:28 AM)admin Wrote: [ -> ]when you download firmware, need remove the RF receiver module.
if can't learn by KCS firmware, maybe your remote's data code not supportted.

Thanks for the reply. I had installed the firmware first and then connected the RF module. So it wouldn't be a compatibility issue, maybe it's just that the RF transmitter I used for the test is not compatible, as you said. I'll try another one. Thanks!

ok