+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20)
+--- Forum: KC868-A4 (https://www.kincony.com/forum/forumdisplay.php?fid=21)
+--- Thread: KC868-A4 with Nextion 5 inch display issue (/showthread.php?tid=1696)
KC868-A4 with Nextion 5 inch display issue - VovaN_60 - 02-11-2022
Hello all.
System:
KC868-A4 board with Nextion NX8048P050-011C-Y display.
Problem:
UART communication with this particular display. Other 2.4 inch Nextion works well.
Possibly issue with TTL level.
Electrical connection info:
RS323 chip (SP3232EEN) removed from the KC868-A4 board.
The RX and TX of Nextion are connected directly to GPIO_16 and GPIO_17 of ESP32.
We have tried to use other GPIO's of ESP32. Nothing works.
The solution which works:
Replacing ESP32-S with original ESP32-WROOVER.
Question:
1) Can anyone suggest a simplier solution?
2) Is there any way to force Nextion to operate on 3.3v TTL level?
3) Can we connect Nextion to RS232 connector directly without removing SP3232EEN?
RE: KC868-A4 with Nextion 5 inch display issue - admin - 02-11-2022
Nextion can work for 3.3v or 5v TTL level. can you confirm with your Nextion model what serial port level use?
if you have test with ESP32-WROOM is no problem, i think the fast way is replace the ESP32 module. Now we sell KC868-A4 board all are use by ESP32-WROOM model, not use ESP32-S. so if I test with your Nextion NX8048P050-011C-Y display, i think it also will be work fine.
about your questions-3, if you connect Nextion without SP3232EEN, you just connect to ESP32's TXD,RXD pin directly. SP3232EEN just for serial level convert, that for 3.3v->12v RS232 level.
RE: KC868-A4 with Nextion 5 inch display issue - YOO SEOK - 11-07-2024
Do you have sample code for kc868 and NEXTION HMI communication connection?