+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20)
+--- Forum: KC868-A16 (https://www.kincony.com/forum/forumdisplay.php?fid=25)
+--- Thread: Factory reset (/showthread.php?tid=2744)
Factory reset - Olsen@HuaHin - 03-28-2023
Hi.
I can no longer find and access my KC868-A16 board by WIFI or LAN.
How to do a factory reset?
RE: Factory reset - admin - 03-28-2023
if you have download the "KCS" firmware. you can HOLD ON the GPIO0 button > 10 seconds. then board will be enable ethernet to DHCP. you can connect with your ethernet cable. use kincony scan deivce tool to find out the IP address of board.
scan device tool download: https://www.kincony.com/download/UDP_SCAN_LIST.zip
RE: Factory reset - Olsen@HuaHin - 03-28-2023
Where is the GPIO0 button, is that the RESET?
RE: Factory reset - admin - 03-28-2023
RE: Factory reset - Olsen@HuaHin - 03-28-2023
Thank you very much.
Working just fine, I get access again from web browser!
RE: Factory reset - admin - 03-28-2023
ok, any questions you can leave message at forum is better.
RE: Factory reset - btzll - 01-12-2025
(03-28-2023, 11:03 AM)admin Wrote: ok, any questions you can leave message at forum is better.
i have a similar issue i cant communicate normally with my board
i tried flashing ESPhome onto it it says succsesfully flashed but its not working i tried to reset but it doesnt help if i plug it into ethernet the lights stay solid on
this is the code in ESPhome
esphome:
name: kc868-a8
platform: ESP32
board: esp32dev
# Wi-Fi Configuration
wifi:
ssid: "IOT1234"
password: "Test1234"
# Optional: Static IP (recommended for stability)
manual_ip:
static_ip: 192.168.1.200
gateway: 192.168.1.1
subnet: 255.255.255.0
# Fallback hotspot (if Wi-Fi is unavailable)
ap:
ssid: "Fallback-Hotspot"
password: "FallbackPassword"
logger:
api:
ota:
platform: esphome
# Relay Configuration
switch:
- platform: gpio
pin: GPIO19
name: "Relay 1"
- platform: gpio
pin: GPIO21
name: "Relay 2"
- platform: gpio
pin: GPIO22
name: "Relay 3"
- platform: gpio
pin: GPIO25
name: "Relay 4"
- platform: gpio
pin: GPIO26
name: "Relay 5"
- platform: gpio
pin: GPIO27
name: "Relay 6"
- platform: gpio
pin: GPIO32
name: "Relay 7"
- platform: gpio
pin: GPIO33
name: "Relay 8"
# Status LED (Optional)
status_led:
pin: GPIO4
RE: Factory reset - admin - 01-13-2025
you have config it use by WIFI, so can't use by ethernet. suggest you remove these command, use DHCP is better:
remove your code:
manual_ip:
static_ip: 192.168.1.200
gateway: 192.168.1.1
subnet: 255.255.255.0