+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20)
+--- Forum: KC868-HA /HA v2 (https://www.kincony.com/forum/forumdisplay.php?fid=55)
+--- Thread: KC868-HA PC software V1.0.5.1011 (/showthread.php?tid=3453)
Pages:
1
2
KC868-HA PC software V1.0.5.1011 - admin - 11-01-2023
make sure your computer have installed CH340 USB-RS232 driver.
HA485_Ctrl_V1.0.5.1011.zip (Size: 912.26 KB / Downloads: 289)
RE: KC868-HA PC software V1.0.5.1011 - mart81 - 02-18-2024
Hi there,
I have two questions:
- Is the PC Software also available for Linux?
- Is it possible to change the Baudrate of the KC868-HA-V2. I have other stuff on my RS485-Bus which needs different Baudrate.
Thanks very much in advance.
RE: KC868-HA PC software V1.0.5.1011 - mart81 - 02-18-2024
Hi there again,
ok, I found out how to change the baudrate.
I changed it to 57600 baud without parity. That worked.
But I need 57600 baud with parity even. It seems that setting parity doesn't work. I tried it with even and odd.
Could you please check that.
My firmware version is V200
Thanks very much in advance.
Martin
RE: KC868-HA PC software V1.0.5.1011 - admin - 02-18-2024
how do you use HAv2, HAv2 connect to KinCony's relay board? or HAv2 connect to raspberry pi directly?
RE: KC868-HA PC software V1.0.5.1011 - mart81 - 02-27-2024
(02-18-2024, 10:55 PM)admin Wrote: how do you use HAv2, HAv2 connect to KinCony's relay board? or HAv2 connect to raspberry pi directly?
I connected it to a KC868-AP. But I have other clients on the bus where I cannot change the communication parameters.
Sorry for my late reply. I did not get a notification.
RE: KC868-HA PC software V1.0.5.1011 - admin - 02-27-2024
KC868-AP not support HA board.
RE: KC868-HA PC software V1.0.5.1011 - mart81 - 02-27-2024
(02-27-2024, 10:51 AM)admin Wrote: KC868-AP not support HA board.
I already used it with KC868-AP and EspHome. It worked with a slower baudrate.
The only problem I have is that I cannot set the right parity. I think it is a bug in HA firmware.
RE: KC868-HA PC software V1.0.5.1011 - admin - 02-27-2024
HAv2 support change baudrate by PC software.
RE: KC868-HA PC software V1.0.5.1011 - mart81 - 02-28-2024
(02-27-2024, 10:24 PM)admin Wrote: HAv2 support change baudrate by PC software
Yes I know. As I said I already did that. But setting parity to anything different than "none" does NOT work. This is why I think there is an error in the firmware of HAv2 or the PC software.
RE: KC868-HA PC software V1.0.5.1011 - admin - 02-28-2024
do you means, the partity only work for "NONE"?