![]() |
KCS V2 auto send ADC values - Printable Version +- Smart Home Automation Forum (https://www.kincony.com/forum) +-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20) +--- Forum: "KCS" v2 firmware system (https://www.kincony.com/forum/forumdisplay.php?fid=40) +--- Thread: KCS V2 auto send ADC values (/showthread.php?tid=7448) |
KCS V2 auto send ADC values - csacomani - 01-23-2025 Dear all, I am using the K868-A4 board with KCS V2.2.10, I have a 4-20mA sensor connected to AI1 and I am receiving the values correctly on the Monitor. https://authomathikacombr-my.sharepoint.com/:i:/g/personal/csacomani_authomathika_com_br/EcwAxPcQMf1Drb4YJdFE-JkBvdIKEmHErIzHgfyHqBZsfA?e=v47SsH My MQTT server is configured and turned on, I receive information from my digital inputs and outputs, when they change their state, but I need to receive the data from my AD1 input, I went to System and activated the "auto send ADC values" option which would have to send me the data every 5 seconds! This does not happen! https://authomathikacombr-my.sharepoint.com/:i:/g/personal/csacomani_authomathika_com_br/ERLWwJsBziVNphY78DI1jvEBdrsVh-gg7byycFJ9vNARoA?e=nnugET What should I do to make this configuration work? RE: KCS V2 auto send ADC values - admin - 01-24-2025 do you have set the "threshold" for every ADC channel, just click "gear" ico to set. RE: KCS V2 auto send ADC values - csacomani - 01-24-2025 (01-24-2025, 01:52 AM)admin Wrote: do you have set the "threshold" for every ADC channel, just click "gear" ico to set. Thanks for the help! Everything works now! RE: KCS V2 auto send ADC values - admin - 01-25-2025 ok, good. |