+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1)
+--- Forum: Development (https://www.kincony.com/forum/forumdisplay.php?fid=4)
+--- Thread: Reset Board ? product reliability (/showthread.php?tid=7471)
Pages:
1
2
RE: Reset Board ? product reliability - jltluc57 - 02-03-2025
I have the right firmware
All this has already been done.
I use static IPs!
And so there is the same IP since we cannot configure two different ones
RE: Reset Board ? product reliability - admin - 02-04-2025
you can set DHCP for testing.
RE: Reset Board ? product reliability - LambrosS - 02-06-2025
Hello
I have also the KC868-A16 with the v2.2.10 firmware and I have the same problem.
As soon as I made any changes and system has to restart the Ethernet port stops to communicate with the switch (led on the switch turns off) and I have to disconnect the supply to the board and reconnect it in order to connect to the card.
I have also turn wifi off but no change.
RE: Reset Board ? product reliability - admin - 02-07-2025
take a video is better.
RE: Reset Board ? product reliability - LambrosS - 02-07-2025
Hello again,
I have enable wifi and select STA mode, put ssid and password. I have also put a static ip on the LAN and restarted the board.
After restarting the board., the Ethernet port was not disconnected from the switch but i couldn't connect to the board.
I removed the ethernet cable from the swich and connected to the boad via Wifi.
From that time i haven't have any disconnection!!!!!
RE: Reset Board ? product reliability - jltluc57 - 02-08-2025
Yes I agree, but it is not normal it must take one of the networks.
The ideal is an IP by type of media.
For me the reliability remains the Lan
RE: Reset Board ? product reliability - jltluc57 - 03-14-2025
I was away, no response from the admin on the subject?