Transmit calculated ADC values via MQTT instead of raw values - Printable Version +- Smart Home Automation Forum (https://www.kincony.com/forum) +-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1) +--- Forum: KC868-A series and Uair Smart Controller (https://www.kincony.com/forum/forumdisplay.php?fid=6) +--- Thread: Transmit calculated ADC values via MQTT instead of raw values (/showthread.php?tid=7858)

Transmit calculated ADC values via MQTT instead of raw values - korl - 03-22-2025 Hello everyone, I have an A6 and an A16. On the A6, an analog sensor (1-5V) is connected to ADC1. The sensor measures the air pressure. Via gear symbol, I defined a calculation, so I don't see the raw value, but the reading in bar: Via MQTT, only the RAW value is transmitted (see left side of the picture). Is it possible to transmit the calculated value (7.29) and unit (bar), so that a possible home assistant auto discovery also shows the correct unit? RE: Transmit calculated ADC values via MQTT instead of raw values - admin - 03-22-2025 maybe in KCS v3 can update it. RE: Transmit calculated ADC values via MQTT instead of raw values - korl - 03-23-2025 Ok, this would a nice feature. it would be worth thinking to move from A6 and A16 to v3