+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1)
+--- Forum: Customer project example (https://www.kincony.com/forum/forumdisplay.php?fid=51)
+--- Thread: Kilcony RS-485 SHT30 Sensor - Setting MODBUS Address (/showthread.php?tid=7918)
Kilcony RS-485 SHT30 Sensor - Setting MODBUS Address - egionet - 04-08-2025
Hello,
I tried changing the MODBUS address from MODBUS ID 1 to 15 on the RS-485 SHT30 temperature and relative humidity module through a function 6 write, disconnected the connector for 5 to 10 seconds, reconnected the connector, and polled the sensor over MODBUS. However, the device only responds to MODBUS ID 1, but I can see the updated MODBUS address in register 0x0a as 0x0F.
Is there another setting that has to be configured?
RE: Kilcony RS-485 SHT30 Sensor - Setting MODBUS Address - admin - 04-09-2025
can you take a photo of your RS485 sensor? whether you are using KinCony TS?
RE: Kilcony RS-485 SHT30 Sensor - Setting MODBUS Address - egionet - 04-10-2025
(04-09-2025, 08:08 AM)admin Wrote: can you take a photo of your RS485 sensor? whether you are using KinCony TS?
I ordered two of these:
https://shop.kincony.com/products/rs485-temperature-and-humidity-sensor-modbus-rtu-use-by-sht30