[arduino code examples for A8v3]-03 Read analog input ports value

Code:
/*

 * Made by KinCony IoT: https://www.kincony.com

 *

 * Description:

 * This Arduino program reads analog values from four analog input pins (A1, A2)

 * and prints the values to the Serial Monitor. The analog inputs are defined with specific

 * GPIO pins and the program reads the voltage levels from these pins every 2 seconds.

 *

 * Pin Definitions:

 * - A1: GPIO 7

 * - A2: GPIO 6



 */



#define ANALOG_A1   7   // Define GPIO pin for analog input A1

#define ANALOG_A2   6   // Define GPIO pin for analog input A2





void setup()

{

    Serial.begin(115200); // Initialize serial communication at 115200 baud rate

    delay(500); // Short delay to allow serial communication to start



    pinMode(ANALOG_A1, INPUT); // Set GPIO 5 as an input for analog signal A1

    pinMode(ANALOG_A2, INPUT); // Set GPIO 7 as an input for analog signal A2



}



void loop()

{

    // Read and print analog values from the defined pins

    Serial.print("A1="); 

    Serial.println(analogRead(ANALOG_A1)); // Read and print the value from A1

    Serial.print("A2=");

    Serial.println(analogRead(ANALOG_A2)); // Read and print the value from A2   

    delay(2000); // Wait for 2 seconds before the next reading

}