+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20)
+--- Forum: "KCS" v2 firmware system (https://www.kincony.com/forum/forumdisplay.php?fid=40)
+--- Thread: "KCS" v2.2.13 firmware BIN file download (/showthread.php?tid=8058)
"KCS" v2.2.13 firmware BIN file download - admin - 05-07-2025
v2.2.13 improvement:
Fix MQTT message comma bug
RE: "KCS" v2.2.13 firmware BIN file download - acztassi - 06-09-2025
hello,
I'm having a problem with A128,
I have 2 inputs that after a long time On, suddenly get off without triggering IFTTT events.
At all I have 30 IFTTT rules, and it does not take a lot of memory...
even the KCS monitor stays off the inputs even having signal.. then I only restart the board, and all works fine
RE: "KCS" v2.2.13 firmware BIN file download - admin - 06-09-2025
can you test with esphome yaml?
what function you wanted?
RE: "KCS" v2.2.13 firmware BIN file download - acztassi - 06-14-2025
The main function that only works with ifttt is to only turn on an output when 6 inputs are true.
RE: "KCS" v2.2.13 firmware BIN file download - admin - 06-15-2025
you can enable IFTTT "AND" logical.
RE: "KCS" v2.2.13 firmware BIN file download - sergiomh96 - 06-22-2025
Hi, I just tested this new version (2.2.13). The temperature sensors do not update in mqtt after varying their value. will it be possible to have this working later?
Thanks!
RE: "KCS" v2.2.13 firmware BIN file download - admin - 06-22-2025
you need to set the "threshold" in sensor webpage firstly, for example, input "0.1". that means , if temperature changed 0.1c will feedback to mqtt.
RE: "KCS" v2.2.13 firmware BIN file download - sergiomh96 - 06-24-2025
(06-22-2025, 11:33 PM)admin Wrote: you need to set the "threshold" in sensor webpage firstly, for example, input "0.1". that means , if temperature changed 0.1c will feedback to mqtt.
Perfect, it works.
Thanks
RE: "KCS" v2.2.13 firmware BIN file download - csacomani - 07-04-2025
I'm having trouble receiving feedback for MQTT!
I'm using a KC868-A4 Rev 1.2.5 board with the new version (2.2.14). In the KCS menu under System, I activated the option to automatically send ADC values.
Then I went to the Motinor, ADC menu, in channel settings and used the following values:
unit: psi
Custom value1 = 0
Custom value2 = 0
Threshold = 0.1
And I'm not getting feedback for MQTT!
Do I have to revert the version to 2.2.13?
RE: "KCS" v2.2.13 firmware BIN file download - admin - 07-05-2025
Custom value2 should set a value, NOT 0
for example, if you want set the ranage is 0-5v, so that:
unit: v
Custom value1 = 0
Custom value2 = 5
Threshold = 0.1