+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20)
+--- Forum: KC868-A16 (https://www.kincony.com/forum/forumdisplay.php?fid=25)
+--- Thread: receive data from switch by RS485 and control output of KC868-A16 (/showthread.php?tid=8662)
receive data from switch by RS485 and control output of KC868-A16 - edg72022 - 10-21-2025
I try to find the way to control Output of KC868-A16.
I found the way to send information from KC868 but not on the other way.
Below a print screen of the way I used to do it.
and the link of data information
D8 Switch RS485
RE: receive data from switch by RS485 and control output of KC868-A16 - admin - 10-21-2025
you can config IF DI1 "RAISE EDGE" THEN send custom protocol1.
then use a RS485-USB adapter to monitor whether have sent.
RE: receive data from switch by RS485 and control output of KC868-A16 - edg72022 - 10-22-2025
(10-21-2025, 10:56 PM)admin Wrote: you can config IF DI1 "RAISE EDGE" THEN send custom protocol1.
then use a RS485-USB adapter to monitor whether have sent.
Is it possible to config IF receive custom protocol1 THEN send DO1 "RAISE EDGE"?
RE: receive data from switch by RS485 and control output of KC868-A16 - admin - 10-22-2025
that need KC868-A16v3 new board, use by KCS v3, KCS v3 support receive customize message as IF condition.