[arduino code examples for KC868-AGv3]-02 RF 433MHz sender

Code:
/*

  Example for different sending methods

  

  https://github.com/sui77/rc-switch/

  

*/



#include <RCSwitch.h>



RCSwitch mySwitch = RCSwitch();



void setup() {



  Serial.begin(9600);

  

  // Transmitter is connected to Arduino Pin #10  

  mySwitch.enableTransmit(digitalPinToInterrupt(2));

  delay(500);

  mySwitch.send(5396, 24);

  

  // Optional set protocol (default is 1, will work for most outlets)

  // mySwitch.setProtocol(2);



  // Optional set pulse length.

  // mySwitch.setPulseLength(320);

  

  // Optional set number of transmission repetitions.

   mySwitch.setRepeatTransmit(15);

  

}



void loop() {



  /* See Example: TypeA_WithDIPSwitches */

  mySwitch.switchOn("11111", "00010");

  delay(1000);

  mySwitch.switchOff("11111", "00010");

  delay(1000);



  /* Same switch as above, but using decimal code */

  mySwitch.send(5393, 24);

  delay(1000);  

  mySwitch.send(5396, 24);

  delay(1000);  



  /* Same switch as above, but using binary code */

  mySwitch.send("000000000001010100010001");

  delay(1000);  

  mySwitch.send("000000000001010100010100");

  delay(1000);



  /* Same switch as above, but tri-state code */ 

  mySwitch.sendTriState("00000FFF0F0F");

  delay(1000);  

  mySwitch.sendTriState("00000FFF0FF0");

  delay(1000);



 // delay(20000); 

  ;

}