+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=87)
+--- Forum: N60 (https://www.kincony.com/forum/forumdisplay.php?fid=88)
+--- Thread: CT Sensor Direction (/showthread.php?tid=9735)
CT Sensor Direction - chuyskywalker - 08-12-2026
From what I've read (and based on most other power monitoring systems) it's important to get the direction of the sensor correct. So, should it look like A or B?
Code:
A)
( )---- Sense Leads ------
Source >-------(--)------------------------> Load
( )
B)
---- Sense Leads ------( )
Source >------------------------(--)-------> Load
( )Thanks!
RE: CT Sensor Direction - admin - 08-12-2026
can you use a photo to show that?
RE: CT Sensor Direction - chuyskywalker - 09-03-2026
I did eventually see the arrow on the product diagram.
The wires from the sensors should be placed in the direction of the load. "Leads to loads", or in the above, option A
RE: CT Sensor Direction - admin - 09-03-2026
ok