KC868-AP dimmer work with RGBW LED strip

[admin]

here is KC868-AP dimmer controller work with DC12V/24V LED strip and wall switch panel.
   

[mahafree]

Is it possible to get an 0-10v output from this board instead of PWM?

[admin]

sure, KC868-AP use for output 0-10v

[mahafree]

Is it possible to provide an example config to output 0-10v?
I'm using ESPhome and home assistant.

[admin]

here is config yaml file for ESPHome:
https://www.kincony.com/forum/showthread.php?tid=2476

[mahafree]

I'm currently using that config.
Every channel outputs a PWM signal.

[mahafree]

I'm trying to do this but with the KC868-AP.

[admin]

sure, just KC868-AP already have led driver circuit on the PCB, KC868-D16 need to add extend led driver.

[mahafree]

This my exact setup.
Is there some parameter I need to change to change the current PWM signal?

   

[admin]

if you want output dc0-10v, you need to use 10v power supply.