Thanks for the answer. But not what I am looking for. Let me rephrase it.
I have a smart automation software that communicates with smart devices on my lan with mqtt. One of my device (IPX800 from GCE) is dead. the cost is about 200€. Hence my interest for Kincony boards. My issue is:
- I am reusing the Temperature sensorfrom my dead device. They call it TC100 (https://www.gce-electronics.com/en/senso...-1042.html). The VCC max is 3.3v. The voltage given by the sensor is translated in °C by the device with the rule calculation ((X* 0.00323) - 0.25) / 0.028.
So my issue with the A4 module is that MQTT transmit a number (like 650). I need to get out of it the temperature. If I apply the previous rule to this number, I get a not valid temp value.
Specifying a min and a max on KCS can give a temperature (but how is it calibrated: just changing the min /max parameters would give a different temp value)
How to do it?
(Unfortunately KCS does not deal with 1wire).
Thanks
I have a smart automation software that communicates with smart devices on my lan with mqtt. One of my device (IPX800 from GCE) is dead. the cost is about 200€. Hence my interest for Kincony boards. My issue is:
- I am reusing the Temperature sensorfrom my dead device. They call it TC100 (https://www.gce-electronics.com/en/senso...-1042.html). The VCC max is 3.3v. The voltage given by the sensor is translated in °C by the device with the rule calculation ((X* 0.00323) - 0.25) / 0.028.
So my issue with the A4 module is that MQTT transmit a number (like 650). I need to get out of it the temperature. If I apply the previous rule to this number, I get a not valid temp value.
Specifying a min and a max on KCS can give a temperature (but how is it calibrated: just changing the min /max parameters would give a different temp value)
How to do it?
(Unfortunately KCS does not deal with 1wire).
Thanks