09-07-2023, 10:02 PM
1. it's OK, every relay is independent.
2. you can use A8 S1,S2 with WS2812 RGB LED strip, not use S3,S4, S3 and S4 only use for ON/OFF signal.such as binary sensor.
3. you can set ethernet by DHCP, so that every board will have different ip address, not conflicts. even if you add many boards work at the same time.
4. now there are two type case of A8:
a. plastic shell
b. aluminium cover with plastic bottom. (this is thin size)
5. you can buy above two type of shell independently.
6. about analog input arduino demo source code: https://www.kincony.com/forum/showthread.php?tid=1606
2. you can use A8 S1,S2 with WS2812 RGB LED strip, not use S3,S4, S3 and S4 only use for ON/OFF signal.such as binary sensor.
3. you can set ethernet by DHCP, so that every board will have different ip address, not conflicts. even if you add many boards work at the same time.
4. now there are two type case of A8:
a. plastic shell
b. aluminium cover with plastic bottom. (this is thin size)
5. you can buy above two type of shell independently.
6. about analog input arduino demo source code: https://www.kincony.com/forum/showthread.php?tid=1606
YouTube: https://www.youtube.com/c/KinCony
Online Store: https://shop.kincony.com
Alibaba Store: https://kincony.en.alibaba.com/
Online Store: https://shop.kincony.com
Alibaba Store: https://kincony.en.alibaba.com/