Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
"KCS" v2.2.10 firmware BIN file download
#21
Я использую плату K868-A16 но при подключении датчика температуры ds18b20 точность 0,5°С хотя датчик может мерить 0,1°С
Reply
#22
Is there a version available for the KC868-ATC? Thanks!
Reply
#23
(02-06-2025, 02:09 AM)AreaKode Wrote: Is there a version available for the KC868-ATC? Thanks!

no, KC868-ATC only have arduino firmware. Not use by KCS firmware.
Reply
#24
hello!!!
i`m having a problem with this version ..
when using ethernet and i make a simple configuration in IFTTT like:

- WHEN DI1 IN BOTH EDGE ... THEN TOGGLE DO1

and in output menu I setup the DO1 to delay (20 seconds) then the ethernet blocks...
even the RJ45 connector leds turn OFF..

tested in A16 and AIO and both boards have the same problem

i tired to turn off and turn on the board... then it start well but a few time after the problem continues and the ethernet stops again

if I only remove the delay configuration to "hold on".. all restart working fine
Reply
#25
next week we test it.
Reply
#26
Hi (KC868-A6)

Seems like the sensor function has some problems at least when posting to mqtt

I have 2 sensors
  • A DS18B20 that seems to have a lot of spurious readings
  • A DHT22 that seems to sit on one value for a very long time, even if other sensors close by shows temperature variations way above the threshold

[Image: 2025-02-18_04_51_38.png]

Other than that it seems like a great product!
Reply


Forum Jump:


Users browsing this thread:
2 Guest(s)