Inputs don't works

[osis]

I'm asking for help because my inputs don't work.
I check by shorting the input to GND - as in the instructions.
Do I need to configure it? I tried various configurations but without any positive effect (picture).

[admin]

download KCS v2 firmware, here is online guide: https://www.kincony.com/esp32-kcsv2-firmware.html
if you want INPUT toggle OUTPUT, set by IFTTT.

[osis]

I have it installed according to the guide you provide in the link.
Everything according to the instructions and the result - the inputs do not work...

Could the motherboard be damaged?

[admin]

take a photo how you wire your board.
take a screen photo how you set IFTTT for INPUT and OUTPUT.

[osis]

take a photo how you wire your board.
take a screen photo how you set IFTTT for INPUT and OUTPUT.

please

[admin]

you need set by IFTTT webpage, let INPUT toggle OUTPUT.
here is KCS v2 firmware online guide: https://www.kincony.com/esp32-kcsv2-firmware.html

[osis]

you need set by IFTTT webpage, let INPUT toggle OUTPUT.
here is KCS v2 firmware online guide: https://www.kincony.com/esp32-kcsv2-firmware.html

I don't have a IFTTT function

[admin]

because you are download OLD firmware, the new KCS v2 firmware at here: https://www.kincony.com/forum/showthread.php?tid=7283
please see the KCS v2 online guide clearly.

[osis]

because you are download OLD firmware, the new KCS v2 firmware at here: https://www.kincony.com/forum/showthread.php?tid=7283
please see the KCS v2 online guide clearly.

when trying to change the firmware, the status is SYNC all the time

[admin]

when download firmware, remove the RF433M receiver from PCB.