Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
I may have fried my board
#1
I think I may have messed up some wiring of input sensors. I think I may have accidentally plugged in a 12v power supply into a digital input or maybe some wires made contact with each other after stapling them into the wall. 


The device went offline at about the time that I was working on it according to home assistant and now the device won’t go online but the lights still work along with all manual controls. 

Is there any trouble shooting I can do or a way to reset the device other than unplugging and replugging?
Reply
#2
you can download KCS firmware again to test the board.
digital input can work with 12v DC level.
Reply


Forum Jump:


Users browsing this thread:
1 Guest(s)