+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=1)
+--- Forum: KC868-A series and Uair Smart Controller (https://www.kincony.com/forum/forumdisplay.php?fid=6)
+--- Thread: KC868-A4S and meanwell ELG-200-24B (/showthread.php?tid=7927)
KC868-A4S and meanwell ELG-200-24B - TMaYaD - 04-10-2025
I'm trying to use meanwell ELG-200-24B to drive 24v LED drive strips using A4S and the LED does not completely turn off. When I checked, there is ~0.58V across the analog output and ground.
What am I doing wrong?
RE: KC868-A4S and meanwell ELG-200-24B - admin - 04-11-2025
KC868-D16 dimmer controller + driver is suitable for dimmable LED strip.
RE: KC868-A4S and meanwell ELG-200-24B - fagolinoabc - 05-02-2025
@Geometry Dash The most likely cause of your issue is the KC868-A4S outputting a residual voltage (~0.58V) when set to “off,” which is above the ELG-200-24B’s dimming threshold, preventing the LEDs from turning off completely. Start by isolating the KC868-A4S output and verifying its behavior, then proceed with the appropriate fix.