which board and button

[Silver]

Translator



Hello,

I would like to know whether the following project is possible and what people think about what I need to order:
I would like to control a rain sprinkler system via home assistant. I think I need a board that is controlled with Ethernet and can control 4-6 relays 24 volt "Hunter 24vac valves (magent coil)".
I would like to have an optional switch, for example
hhttps://shop.kincony.com/products/touch-switch-panel-dry-contact-signal?variant=43573355511973 or hhttps://shop.kincony.com/products/8-gang-wall-toggle-reset-switch-push-button-momentary-contact-for-smart-home-automation-diy

If necessary, you can control the release without a home assistant or an app.

Thank you
Dennis

[admin]

yes, you can use either one connect to KinCony relay board's digital input ports.

[Silver]

Hello,

is there a device that can switch up to 8 relays? 
I would like to control valves from HUNTER PGV 101GB "https://www.hunterirrigation.com/de/irrigation-product/ventile/1-pgv". 
According to the data sheet, these valves must be controlled with 24 volts AC (alternating current). 
In addition, I would like to be able to control the board with LAN (RJ45) using Home Assistant (for example via Esphome). 

Thank you

[admin]

you can use KinCony KC868-A8,A8S,A8Sv2,F8 relay controller, all are ok.