EZO sensor not working

[admin]

you need to send command to sensor to enable i2c. sorry, i am not used it before. mabye you can contact with sensor's seller.

[TeRRia]

OK let me try testing all of this on a separate ESP32 board. Will share results.

[admin]

good luck.

[TeRRia]

good luck.

Thanks Admin. So I made good progress!

Anybody using Atlas Scientific probes: While it works with both UART and I2C, by default the probe is set on UART.

To switch the board to I2C, follow these steps:
Interfacing Atlas Scientific Ph Sensor with Arduino via UART/I2C (how2electronics.com)

UART: led is green, with I2C activated, it's blue.

Once done, you will see your probe in the logs.

Admin: How do I connect 2 probes (I have a pH and ORP) ?

First one is connected using the I2C extender and this works fine. 
Second one: I tried using the I2C connector on top of the E16P board but it doesn't work.

   
   

[admin]

First one is connected using the I2C extender and this works fine. use by which board? which port? can you upload a photo?