Mqtt a16

[davidov.aleksandr1985@gmail]

hello. help me figure out the MQTT settings on the KC868 a16 board. the task is to configure the board outputs on a third-party mqtt broker(wqtt.ru ) to work with the voice assistant (Alice)

[admin]

just download KCS v2 firmware by usb-c cable, then set enable mqtt protocol, set the mqtt broker's ip , port, user name, password.
here is KCS v2 online guide: https://www.kincony.com/esp32-kcsv2-firmware.html

[davidov.aleksandr1985@gmail]

hello. I've already done that. but the web interface shows that there is no confirmation to the mqtt broker

[admin]

take a photo of your mqtt setting.

[davidov.aleksandr1985@gmail]

Поправьте меня если я где то ошибся.

---

correct me if I made a mistake somewhere.

---

Поправьте меня если я где то ошибся.

[admin]

in KCS webpage, you should add "mqtt://" before your mqtt broken domain name.

[davidov.aleksandr1985@gmail]

connected. thank you)))

[davidov.aleksandr1985@gmail]

hello. One more question. when changing the state of the output relay manually (via a switch), should the states of all relays be sent to topik, or just one?

[admin]

all relay will feedback.