No AP appears

[sergey1945]

I just bought the KS868 A6 board and successfully flashed the firmware according to the instructions. However, after reconnecting the power, I can't detect the Wi-Fi access point. When power is applied, the red LED near the power connector lights up, and all relays click. No other activity on the board. Tried firmware KCS_KC868_A6_V2.2.13 and KCS_KC868_A6_V2.2.14. My board arrived in a very dented package, so I'm concerned about the Wi-Fi module. Is there any way to diagnose the Wi-Fi module? Could this issue be related to me temporarily using a DC 12V 1A?

[admin]

can you take photo , how you wire your board.
usually we suggest use DC12V 2A power supply.

[sergey1945]

can you take photo , how you wire your board.
usually we suggest use DC12V 2A power supply.

   

   

[sergey1945]

Plugged the board into a 2A DC adapter, but the hotspot didn’t show up.

---

Plugged the board into a 2A DC adapter, but the AP didn’t show up.

[admin]

because you have not downloaded firmware, you have not selected first row. see my photo step3: enable item.

[sergey1945]

Oops, my bad—missed that line. Always double-check the instructions! Thanks for saving me!