Smart Home Automation Forum › Technical Support › KC868-M16 / M1 / MB / M30 v
Details for M30 board

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Details for M30 board
admin Online
Administrator
*******
Posts: 9,308
Threads: 1,207
Joined: Oct 2020
Reputation: 238
#6
01-23-2024, 04:35 AM
Would the 5A clamps be accurate enough to measure loads of 1-2 Watts ? AC220v load 2W? it's too small for CT sensor.
No calibration needed with this M30 setup? Yes, not need.
YouTube: https://www.youtube.com/c/KinCony
Online Store: https://shop.kincony.com
Alibaba Store: https://kincony.en.alibaba.com/
Find
Reply


Messages In This Thread
Details for M30 board - by nickdd - 01-22-2024, 12:06 AM
RE: Details for M30 board - by admin - 01-22-2024, 12:30 AM
RE: Details for M30 board - by nickdd - 01-22-2024, 08:07 PM
RE: Details for M30 board - by admin - 01-22-2024, 09:47 PM
RE: Details for M30 board - by nickdd - 01-22-2024, 10:51 PM
RE: Details for M30 board - by admin - 01-23-2024, 04:35 AM
RE: Details for M30 board - by nickdd - 02-16-2024, 07:30 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)