02-08-2025, 03:35 PM
Hello,
I would like to know if it is possible to send ASCII or HEX commands to the KC868-A16 via LAN with UDP or TCP protocol through a Biamp Impera Tango control processor.
I've already looked for some information on the forum but I can't find it.
I need to know if there are strings so I can make a driver and the Biamp processor sends commands to the K868-A16.
I have two relay boards from another brand at home that receive ON/OFF commands via LAN using the UDP protocol.
If I have the strings I can make a driver to control the KC868_A16 through the Biamp control processor
My Biamp processor only has 8 I/O ports and I need more, so I bought the K868-A16.
Can you help or is the KC868-A16 designed for another type of application?
I appreciate any help you can send.
I would like to know if it is possible to send ASCII or HEX commands to the KC868-A16 via LAN with UDP or TCP protocol through a Biamp Impera Tango control processor.
I've already looked for some information on the forum but I can't find it.
I need to know if there are strings so I can make a driver and the Biamp processor sends commands to the K868-A16.
I have two relay boards from another brand at home that receive ON/OFF commands via LAN using the UDP protocol.
If I have the strings I can make a driver to control the KC868_A16 through the Biamp control processor
My Biamp processor only has 8 I/O ports and I need more, so I bought the K868-A16.
Can you help or is the KC868-A16 designed for another type of application?
I appreciate any help you can send.