03-23-2025, 01:25 AM
I'm currently toying around with the T16M before putting it into a wall and calling my project "working".
While experimenting, I started messing around with measurements ( hence my questions on https://www.kincony.com/forum/showthread.php?tid=7423 ).
I've wired my board similar to what I've found in these posts:
* https://www.kincony.com/forum/showthread.php?tid=7211
* https://www.kincony.com/forum/showthread.php?tid=2221 (this schematic is really clear, by the way, thank you!)
While testing out the board, I noticed that the voltage between `V-` and a disabled `V+` pin (see picture below) is **non-zero** (measures 2.385V).
I'm wondering if something is wrong with the board, or if the ESPHome settings don't completely disable the pin?
It may also be a misunderstanding of mine in how MOSFET-based switching works, so feel free to also tell me that my use-case is wrong
![[Image: pEQGS2V.png]](https://snipfly.io/uploads/pEQGS2V.png)
https://snipfly.io/pEQGS2V.png
While experimenting, I started messing around with measurements ( hence my questions on https://www.kincony.com/forum/showthread.php?tid=7423 ).
I've wired my board similar to what I've found in these posts:
* https://www.kincony.com/forum/showthread.php?tid=7211
* https://www.kincony.com/forum/showthread.php?tid=2221 (this schematic is really clear, by the way, thank you!)
While testing out the board, I noticed that the voltage between `V-` and a disabled `V+` pin (see picture below) is **non-zero** (measures 2.385V).
I'm wondering if something is wrong with the board, or if the ESPHome settings don't completely disable the pin?
It may also be a misunderstanding of mine in how MOSFET-based switching works, so feel free to also tell me that my use-case is wrong
https://snipfly.io/pEQGS2V.png