(04-14-2025, 02:53 PM)admin Wrote: what power supply you are using? 12V how many current A?
12V 2A . The supply of an NUC .
here is log with tasmota install
Code:
rst:0x3 (SW_RESET),boot:0x17 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DIO, clock div:2
load:0x3fff0030,len:6656
load:0x40078000,len:15052
load:0x40080400,len:3836
entry 0x4008069c
I (52) boot: ESP-IDF v4.4.7-dirty 2nd stage bootloader
I (53) boot: compile time 12:46:57
I (53) boot: Multicore bootloader
I (57) boot: chip revision: v3.1
I (61) boot.esp32: SPI Speed : 40MHz
I (66) boot.esp32: SPI Mode : DIO
I (70) boot.esp32: SPI Flash Size : 4MB
I (75) boot: Enabling RNG early entropy source...
I (80) boot: Partition Table:
I (84) boot: ## Label Usage Type ST Offset Length
I (91) boot: 0 nvs WiFi data 01 02 00009000 00026000
I (98) boot: 1 phy_init RF data 01 01 0003f000 00001000
I (106) boot: 2 factory factory app 00 00 00040000 003b0000
I (113) boot: End of partition table
I (118) esp_image: segment 0: paddr=00040020 vaddr=3f400020 size=fe9d0h (1042896) map
I (504) esp_image: segment 1: paddr=0013e9f8 vaddr=3ffb0000 size=01620h ( 5664) load
I (506) esp_image: segment 2: paddr=00140020 vaddr=400d0020 size=a2c70h (666736) map
I (751) esp_image: segment 3: paddr=001e2c98 vaddr=3ffb1620 size=01d7ch ( 7548) load
I (754) esp_image: segment 4: paddr=001e4a1c vaddr=40080000 size=0fa9ch ( 64156) load
E (783) esp_image: Checksum failed. Calculated 0x5c read 0x58
E (783) boot: Factory app partition is not bootable
E (783) boot: No bootable app partitions in the partition table
ets Jul 29 2019 12:21:46It's possible i erased the bootloader and table partitions? how can i recovery it?