05-29-2025, 03:30 PM
Good afternoon, thank you for the feedback. I tried to activate it again and now it’s working. However, I have some doubts about how I can add an SHT31 sensor via the I2C port. Is it possible? Which port should I connect it to? This is what appears in the terminal: /dev/i2c-0 /dev/i2c-1 /dev/i2c-10 /dev/i2c-22. I would really appreciate your help!
Also, I need to install a motion sensor and a magnetic contact for a home alarm automation. Could you clarify where I should connect them so that I can get an output on the relays when they are triggered? Thank you very much in advance for your help.
Best regards, Rui
Also, I need to install a motion sensor and a magnetic contact for a home alarm automation. Could you clarify where I should connect them so that I can get an output on the relays when they are triggered? Thank you very much in advance for your help.
Best regards, Rui