09-12-2025, 01:15 PM
Just received myT16M in the mail this morning and I'm performing some test.
I installed the KCS 3.12 firmware and the servers webgui etc came up as expected.
Under the tab System there is this option: "Keep Output After Restart"
With this enabled I expected the outputs to com up in the last known state before restart or powertoggle, but all outputs comes up in a off state
Br Steen from Denmark
I installed the KCS 3.12 firmware and the servers webgui etc came up as expected.
Under the tab System there is this option: "Keep Output After Restart"
With this enabled I expected the outputs to com up in the last known state before restart or powertoggle, but all outputs comes up in a off state
Br Steen from Denmark