Smart Home Automation Forum › "KCS" v3 firmware system › "KCS" v3 firmware
dht22 on T64M

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
dht22 on T64M
admin Offline
Administrator
*******
Posts: 9,816
Threads: 1,334
Joined: Oct 2020
Reputation: 249
#2
10-12-2025, 11:16 PM
take photo of your DHT22 sensor setting screen on KCS firmware.
1: output pwm by free GPIO is ok, if you config by esphome or your own Arduino code.
2: sure, config by IFTTT on KCS.
3: KCS not support BM280 directly, you can config by ESPHome.
YouTube: https://www.youtube.com/c/KinCony
Online Store: https://shop.kincony.com
Alibaba Store: https://kincony.en.alibaba.com/
Find
Reply


Messages In This Thread
dht22 on T64M - by Bejakke - 10-12-2025, 04:28 PM
RE: dht22 on T64M - by admin - 10-12-2025, 11:16 PM
RE: dht22 on T64M - by Bejakke - 10-13-2025, 02:21 PM
RE: dht22 on T64M - by admin - 10-14-2025, 01:32 AM
RE: dht22 on T64M - by Bejakke - 10-14-2025, 05:33 PM
RE: dht22 on T64M - by admin - 10-14-2025, 11:13 PM
RE: dht22 on T64M - by admin - 10-16-2025, 01:09 AM

Forum Jump:


Users browsing this thread:
1 Guest(s)