12-10-2025, 09:02 PM
I think to design a system based on the attached drawing.
The server PI-5 will be used to run Home assistant.
1. Is this design correct ?
2. Can I do this using the Kincony bin-files ? ( I have no experience with esphome)
3. Is it possible that the different board communicate with each other directly over RS485 bus. ( for ex. input on one board can activate an output on another board without passing home assistant)
4. Is there a bin-file available for the KC868-AP board ?
5. Are demos available for these boards ?
The server PI-5 will be used to run Home assistant.
The server PI-5 will be used to run Home assistant.
1. Is this design correct ?
2. Can I do this using the Kincony bin-files ? ( I have no experience with esphome)
3. Is it possible that the different board communicate with each other directly over RS485 bus. ( for ex. input on one board can activate an output on another board without passing home assistant)
4. Is there a bin-file available for the KC868-AP board ?
5. Are demos available for these boards ?
The server PI-5 will be used to run Home assistant.