01-10-2026, 08:19 PM
@admin,
thank you for your answer and my apologize for late response.
I don't know what kind of 'dry contact signal module' should I use.
When I asked I didn't have an optocoupler on on my desk. Now I have and tested its behavior.
When 230V is ON, and 3.3V is connected to the plus contact and GND, voltage between the plus contact and output contact is 3.3V.
Could you help me figure-out where to connect output to the KC868-A6 board?
Thank you in advance.
thank you for your answer and my apologize for late response.
I don't know what kind of 'dry contact signal module' should I use.
When I asked I didn't have an optocoupler on on my desk. Now I have and tested its behavior.
When 230V is ON, and 3.3V is connected to the plus contact and GND, voltage between the plus contact and output contact is 3.3V.
Could you help me figure-out where to connect output to the KC868-A6 board?
Thank you in advance.