03-02-2022, 10:25 PM
Hi,
I have figured this one out.
I had this controller set up before MQTT settings, so I used NodeRed and flows. I would like to avoid the reconfiguring to MQTT.
It seems that after MQTT upgrade, when the workmode is set to TCP server the comunication between input panel and the controller stops working as described earlier in the thread.
When the workmode is set to MQTT, TCP client or UDP, the input panel works, but the nodered communication does not(I know that is shouldnt work in these three workmodes).
Any suggestions?
I have figured this one out.
I had this controller set up before MQTT settings, so I used NodeRed and flows. I would like to avoid the reconfiguring to MQTT.
It seems that after MQTT upgrade, when the workmode is set to TCP server the comunication between input panel and the controller stops working as described earlier in the thread.
When the workmode is set to MQTT, TCP client or UDP, the input panel works, but the nodered communication does not(I know that is shouldnt work in these three workmodes).
Any suggestions?