07-11-2022, 03:07 PM
(This post was last modified: 07-11-2022, 10:27 PM by ahmedk4444@yahoo.com.)
Thanks for short reply
As i understood there is no neccessary to connect A16 and server to load through E8 or E16 relays since the H32BS and D8 connected and sufficient for that purpose.
This mean A16 and the server to provide Support to all controllers on the computer network controllers ( AG, D8 H32B, H32BS, ...etc) using home asistance only.
Since my lighting on/off load is 16 circuits only if i knew this earlier of order wouldn't order H32BS and use the server to do it that connect to the load through 2E8 or E16 and save the cost of H32BS.
Last but not list what is advantage to add A16 to the server and what is the adding value for this?
In my casr as i understood from reply power on the server, A16 and connect to ethermet / wifi and install configure software to support the all KC controllers and no load connected to the server/A16 in tjis case.
As i understood there is no neccessary to connect A16 and server to load through E8 or E16 relays since the H32BS and D8 connected and sufficient for that purpose.
This mean A16 and the server to provide Support to all controllers on the computer network controllers ( AG, D8 H32B, H32BS, ...etc) using home asistance only.
Since my lighting on/off load is 16 circuits only if i knew this earlier of order wouldn't order H32BS and use the server to do it that connect to the load through 2E8 or E16 and save the cost of H32BS.
Last but not list what is advantage to add A16 to the server and what is the adding value for this?
In my casr as i understood from reply power on the server, A16 and connect to ethermet / wifi and install configure software to support the all KC controllers and no load connected to the server/A16 in tjis case.