11-05-2020, 07:51 AM
(11-04-2020, 02:31 PM)subas Wrote:Dear Admin(11-01-2020, 01:09 AM)admin Wrote: Protocol: https://www.kincony.com/smart-controller...tocol.html
2.Read status of one relay:
Send: RELAY-READ-255,x (x is the channel of Relay)
Feedback: RELAY-READ-255,x (x is the channel of Relay), y ( status 0 / 1), OK/ERROR
5.Read all relays status by one command:
Send: RELAY-STATE-255
Feedback:RELAY-STATE-255,D3,D2,D1,D0,OK/ERROR
Dear Admin.
Thank you for your feedback. i will try this.
i am having some issue.
How to i make the LED light turn "ON" or "OFF" to show the status of the relay?
i have tried using the "TCP IN" Node and i can get the status of the relay if its turn ON or OFF as per my screen shot attached.
But. how can i turn that LED ON to show the ON status of the relay and LED OFF to show the OFF status of the relay? i am not sure which node to use?
Thank You
Regards
Subas
Regards
Subas