ESPHOME, KC868-A4S, sim 800l

[SERJ_lebedev]

Hi,
Can you advise me how to configure sim800l for use with esphome firmware?
Currently yaml is like this:

Code:

uart:
  baud_rate: 9600
  tx_pin: 15
  rx_pin: 13
sensor:
  - platform: sim800l
    rssi:
      name: "Sim800L RSSI" 
      id: rssi
binary_sensor:
  - platform: sim800l
    registered:
      name: "Sim800L Registered"

but no sensors work in homeassistant....


I have a TTGO T-Call V1.4 board with the same sim 800l module.
everything works fine
The only thing is that there are additional module settings in yaml:

Code:

switch:
  - platform: gpio #SIM800_PWKEY
    pin: 4
    restore_mode: ALWAYS_OFF
    id: SIM800_PWKEY
  - platform: gpio #SIM800_RST
    pin: 5
    restore_mode: ALWAYS_ON
    id: SIM800_RST
  - platform: gpio #SIM800_PWR
    pin: 23
    restore_mode: ALWAYS_ON
    id: SIM800_PWR

thanks!