Driver recommendation for 24V LED strip

[TMaYaD]

Hi
I want to control and dim 24v LED strips using a controller like KC868-A4S. I'm looking for any recommendations for drivers.

I've tried Meanwell ELG-200-24B. But it doesn't turn off completely.

Any inputs are appreciated.

[admin]

if you want use dimmable led strip, suggest you chose KC868-D16 dimmer controller +24V power driver.

[TMaYaD]

Unfortunately, I couldn't find any info on how to run esphome on D16.

Additionally I prefer to have single device per area of my home and A4S with 0-10v channels, relays and inputs matches the use case perfectly... If only I could figure out how to actually use the 0-10v output correctly.

I couldn't find the schematic for D16 either. Though I'm not an expert when it comes to electronics, It would help to compare how A4S differs from D16.

[admin]

D16 integrate to home assistant by mqtt, here is guide: https://www.kincony.com/d16-dimmer-integ...-mqtt.html

[TMaYaD]

Home assistant aside, I still want to use esphome.

[admin]

we will design new esp32 dimmer board in this year.

[alex12312326]

Home assistant aside, I still want to use esphome.

Just use pca9685 module to extend your controller logical pwm outputs with I2C-bus  and PWM-shifter boards to convert low-level pwm signal to your led strip appropriate voltage . I have 10 pwm controlled channels for 24v led strips by this way. Esphome code is standard:  pca9685 platform,  LEDC platform, PWM platform