The response to clicks does not work correctly

[skench]

Hello, I configured the kincony A8 v1.6 as follows. I have the latest firmware available for this model at the moment v2.2.13.

I am trying to configure the switch so that a single press turns on relay 8, and a long press turns on relays 1 through 4, but I don't like that even if I make a long press, relay 8 turns on, which should only turn on with a short press, and I don't want to constantly turn it off after making unnecessary movements, how can I fix this?

The goal is to turn on relay 8 with a short press, turn on relays 1 through 4 with a long press, and not even turn on relay 8.

A video demonstrating my setup is below.


https://cloud.mail.ru/public/kzD9/foVXqnA1Z


Help me PLZ.

[admin]

after you config IFTTT. do you have re power on of board? it MUST need reboot.

[skench]

after you config IFTTT. do you have re power on of board? it MUST need reboot.

Yes, I tried rebooting the equipment, but it doesn't help, when holding the key for a long time, relay number 8 still works, I tried working with different IF by enabling the logical AND parameter, but my attempts have been unsuccessful so far.

[admin]

we will test.

[skench]

we will test.

Good afternoon, please advise the time frame for my question, when will you be able to test it?

[admin]

we will test after 1 week, because KC868-A8 not in stock now.

[admin]

if you want use click and hold on at the same time, you should chose "single click" instead of "rising edge". we have tested ,it's ok.
   
   
   

[skench]

Thanks, I'll really be able to check in 2 weeks.

I have kincony controllers already assembled in the dashboard.

Thank you very much, I love your product.

[admin]

ok, good.