Kincony AS

[admin]

use this arduino code to test your microphone hardware whether is well.
https://www.kincony.com/forum/showthread.php?tid=6897

[fdcemb5]

use this arduino code to test your microphone hardware whether is well.
https://www.kincony.com/forum/showthread.php?tid=6897

I successfully compiled and uploaded the Arduino code. When I attempted to flash the AS with the bin file after setting the parameters and clicking Start, no response was received; it simply idled. So, the process was not complete, and I could not carry out the mic test. What went wrong? See attached picture

[admin]

arduino code whether run well? when have sound, serial port output different numbers.

[fdcemb5]

arduino code whether run well? when have sound, serial port output different numbers.

Arduino code ran well, but no output on the Serial port, see photo

[admin]

where you bought from, if microphone is broken, we will re send you a new AS. Tell us your order number, whether bought from kincony official store?

[fdcemb5]

where you bought from, if microphone is broken, we will re send you a new AS. Tell us your order number, whether bought from kincony official store?

We bought four from your store, and the four are behaving the same: Order Number 2557
2557

[admin]

4pcf of AS all can't work?

[fdcemb5]

4pcf of AS all can't work?

Yes, unfortunately. We noticed that the speakers were out of place, which we have since corrected.

[fdcemb5]

I started over to configure Kincony AS, but was unsuccessful. I have attached all the pictures of my configuration. The Wake Word appears unavailable. Kindly debug this issue as I have used three different HA installation with the same result. I bought four of these device. Kindly consider resolving this urgently.

[admin]

check your home assistant setting.

   
   
   
   
   
newest yaml file download at here: https://www.kincony.com/forum/showthread...904&page=2