A16 flash problem

[admin]

just download KCS firmware , then directly to use board, why download arduino code again?

[zeltini1401]

Because the Lan wire is not identified. I think if I put another sketch, the lan wire will be identified. I started from the beginning. I loaded only the KCS_KC868_A16_V2.1.9.bin file according to the instructions. There is a wifi network. Lan cable shows as "Unidentified Network".
I also changed the IP address in the Lan properties to: 192.168.1.200
255.255.255.0 but no change.

[admin]

do you let A16 connect to your router by network cable? or you use network cable connect A16 with your computer directly?

[zeltini1401]

do you let A16 connect to your router by network cable? or you use network cable connect A16 with your computer directly?

The laptop is connected to the board with a usb to lan adapter.

[admin]

no, you should let your A16 and computer connect to same router.

[zeltini1401]

no, you should let your A16 and computer connect to same router.

The connection to the Lan wire was successful through the router. Thank you.

I want to solder wires to the switches of the Hardi hc2500 control panel and connect them to the relays of this board.
How can I wire together this board with AgIO v5.7 to make the relays work.

[admin]

sorry, i don't know your hc2500 control panel how it works. maybe you need confirm with the supplier, how to connect a extend relay board, whether have some interface for integration.