Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
KC868-H32BS v 1.44 x PZEM 017 DC
#1
Hello, I would like to know if it is possible to use the RS485 port to receive the reading data from a pzem 017 dc to integrate with the Home Assistant using MQTT. Thanks.
Reply
#2
no, the RS485 of H32BS is "slave" mode, use for integrate by other "master" device.
Reply
#3
OK, Thanks.
Reply
#4
(01-31-2022, 04:55 PM)rodrigomallmann Wrote: OK, Thanks.

Hi. Probably it's possible with COLB, but only with Node-Red. Sadly there is no flow available for this. I have a Kincony energy meter and a COLB device, the data flows in to COLB but cannot use in Home Assistant without the above mentioned Node-Red flow.
Reply
#5
if you use Node-Red on raspberry pi, i suggest you use a USB-RS485 adapter, let pi connect with kincony power energy meter directly, the meter use by MODBUS protocol , easy to integrate with home assistant, not need via COLB.
Reply


Forum Jump:


Users browsing this thread:
1 Guest(s)