KC868-A6 ESP32 I/O pin define

[admin]

#define ANALOG_A1  36
#define ANALOG_A2  39
#define ANALOG_A3  34
#define ANALOG_A4  35

DS18B20/DHT11/DHT21/LED strip -1: 32
DS18B20/DHT11/DHT21/LED strip -2: 33

DAC1:26
DAC2:25

IIC SDA:4
IIC SCL:15

Input_IIC_address 0x22

Relay_IIC_address 0x24

RS485 RXD: 14
RS485 TXD: 27

SPI_Bus: (For LoRA/nRF24L01)
CS: 5
MOSI: 23
MISO: 19
SCK: 18

LoRA sx1278:
RST:21
DIO0:2

nRF24L01:
CE: 22

RS485:
TXD:27
RXD:14

RS232:
TXD:17
RXD:16

Extend serial port on PCB:
TXD(define by yourself):12
RXD (define by yourself) :13

[gilad]

#define ANALOG_A1  36
#define ANALOG_A2  39
#define ANALOG_A3  34
#define ANALOG_A4  35

DS18B20/DHT11/DHT21/LED strip -1: 32
DS18B20/DHT11/DHT21/LED strip -2: 33

DAC1:26
DAC2:25

IIC SDA:4
IIC SCL:15

Input_IIC_address 0x22

Relay_IIC_address 0x24

RS485 RXD: 14
RS485 TXD: 27

SPI_Bus: (For LoRA/nRF24L01)
CS: 5
MOSI: 23
MISO: 19
SCK: 18

LoRA sx1278:
RST:14
DIO0:21

nRF24L01:
CE: 22

RS485:
TXD:27
RXD:14

RS232:
TXD:17
RXD:16

[RenePL]

I would like to use IO-1/IO-2 (originally intended for sensors ect. DS1820) as pure GIPO.
I understand that I have to remove two resistors from the print.
I need to use the board to communicate with the furnace via OpenTherm. What pins should I use for input/output?
Design https://ihormelnyk.com/opentherm_adapter

[admin]

IO1 and IO2 in KC868-A6 can use for DS18B20 directly.

[sm4l]

IO1 and IO2 in KC868-A6 can use for DS18B20 directly.

No one of this firmwares worked. 

ESP dont expose WIFI SSID

[admin]

download KCS v2 firmware for KC868-A6

[sm4l]

download KCS v2 firmware for KC868-A6

thanks! 

im was in a old version of KCS.   

Now im using KCS_KC868_A6_V2.2.12 and its working fine! 

Do you have any datasheet for the HTTP server and other protocols functions? i already have the MQTT protocol datasheet.

[admin]

https://www.kincony.com/forum/showthread.php?tid=3106