08-24-2022, 11:53 PM
(08-20-2022, 12:50 AM)admin Wrote: 1. take a photo how you wire switch terminal board with your wall switch.
I attached some photos for wiring executed W6 on one gang and other on common, W 8 on one gang and other on common W10,11,12 on one gang and the other wire to common, W14,15 on one gang and other wire to Common, W16 on one gang and other on common, W 6, 8 working but significant delay response and hanging , other not switch on or off completely.
2. suggest you connect your motor to A16's output. it's easy to set "interlock" mode by A16's ESPHome config file, just change a little code, you can see this video tour, that is demo for E16S, not also can use for A16's setting. https://youtu.be/eEnQ2hHE1JM
A16 will be connected beside the server to main control DB indoor and A16 will be far away and no wires to reach the shutter / Curtain
3. H32B's input only use for dry contact, can't input ac220v, that will be broken for controller. you can create "automation" in home assistant. let inputX trigger some actions that you can define. just define an "automation" such as relay1 ON, relay2 ON, ...... that trigger with inputX.
i took the output of Hunter irrigation contacts that provide 48 volt to the electrical water valve ( solonoid) and unfortunetely it is showing the input all the times trigger either if no order came from the irrigation panel to open the solonoid, i removed the wires and now no trigger for the H32B controller until ask you why trigger the 6 inputs of H32B while no volt goes to water electric valve?
4. this also is "automation" function, just "sunrise" and "sunset" created in home assistant as a sensor, then trigger "automation" by this sensor.
Please guide me to the instruction how to do this ( video + steps) with thanks
5. already given you the video tour, you just do as that video. https://youtu.be/np2JzhAPl3M
i will try to review again if failed i appreciate to look at it today morning with Any Desk
6. Further Question please: the power cut off and after return i found the server changed the ip from 192.168.1.9 instead of 192.168.1.8, i lost control to A16, server and connected H32B, do you agree that it is important to have a static ip for all Kincony devices to avoid DHCP change ip dynamically and loose control, i abled to change all information in Yaml and web device configuration and point out to the new ip however possible my family can't do so and i need good stability not open the programming each time electricity cut off. if you agree with me on this can you please guide me how i can change the web confirguration of home assistant to static ip ?