Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
KC868-A2 configure yaml for ESPhome
#11
(09-27-2023, 06:52 AM)admin Wrote: if router not ready, esp32 will always try to connect with ethernet connection.
you can download KCS firmware for a test. just let esp32 board power on, then router power off,  wait for a moment, router power on, then check esp32 whether is connected to router by ethernet.

Thank you. I would expect what you say to be the normal behaviour; nevertheless, it just doesn't do that with esphome.
It does, however, work with tasmota using this template. https://templates.blakadder.com/kincony_KC868-A2.html

Also, with esphome you can only use ethernet or wifi. With Tasmota both work without problem
Reply


Forum Jump:


Users browsing this thread:
1 Guest(s)