KC868-AI RS485 & EspHome

[pietervanstee]

Hi,

I'm setting up my KC868-AI in EspHome, but I can't seem to find any information about the integration of RS485 in there.
Please let me know how I can add an additional device (RS485 Ultrasone Wind Snelheid En Richting Sensor Temperatuur Vochtigheid Noise PM2.5 Druk Licht Neerslag Kleine Weerstation)

Thanks
Pieter

[admin]

if you are using RS485 sensor, you can connect to raspberry pi's USB-RS485 adapter directly. then integrate to home assistant by it's protocol.

[xoor]

@admin
Is it possible to use fw KCS KC868-AI as modbus GW? I have a modbus-RTU device and I wanted to connect it via AI RS485 and use it as modbus-tcp/UPD/HTTP requests.

[admin]

KCS let RS485 modbus work as "SLAVE" mode. if you want work as "MASTER" mode, i think you can config KC868-AI by ESPHome, so that you can do anything.