Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Control defaults to TCP after power cut
#1
Hi there 

I have an issues with the KC868-Server unit. The unit is set to MQTT work mode, but sometimes after a power cut the controller reverts back to TCP mode. How can I set it to always start in MQTT mode?
Reply
#2
what's your firmware version?
Reply
#3
Ill update the firmware for this device and test again. Which firmware is the correct version for the KC868-Server unit, is it the 32BS?
Reply
#4
i don't understand which controller you are using? KC868-Server or KC868-H32BS?
Reply


Forum Jump:


Users browsing this thread:
1 Guest(s)