KC868-H4 will support RELAY-KEY ?

[phil]

Hello,

has the KC868-H4 Rev. 1.1 FW-Version 1.598,
in this Version support only the signal change

Input 1 - ON
"RELAY-ALARM-1,OKRELAY-ALARM-1,OK"
"RELAY-GET_INPUT-255,254,OK

Input 1 - OFF
"RELAY-ALARM-1,OKRELAY-ALARM-1,OK"
"RELAY-GET_INPUT-255,255,OK"

the processing of the signals in Home Assistant is therefore more complex,

I have seen that the RELAY-KEY function is supported by a new firmware
RELAY-KEY-255,1,0,OK
RELAY-KEY-255,1,1,OK
Will this firmware also be available for the KC868-H4 and H8


https://www.youtube.com/watch?v=WzvKwCVTNk0&t=298s
https://community.home-assistant.io/t/32...155647/119

[admin]

I think you not need to use send query command to read relay state. Because every time if controlled by wall switch panel or wireless remoter will auto feedback command "Feedback:RELAY-KEY-255,x,1,OK （x is the channel of Relay）"
another relay feedback commands are :

RELAY-SET-255,x,1,OK (Turn ON Relay x successed) this is turn on/off one relay's feedback
RELAY-SET_ALL-255,D3,D2,D1,D0,OK this is turn on/off all relays' feedback.

You just have to analyze these commands for relay state update.

relay controller's input port is for alarm sensor use, not for manual control.

[phil]

Hello,
have switched an input and want to use this as a switch only via Home Assistant
After switch "ON" input, get 4 x time the signal "RELAY-ALARM-1,OKRELAY-ALARM-1,OK"
if the switch stays "ON" I still get no more signal.
Then I have to ask every time the status, "RELAY-GET_INPUT-255,254"
thought can use the flacks, like RELAY-KEY...
Do you have an example for Node-Red how I can build it to control the input status ON and OFF, in the video what only ON but not the LOOP with status check.

[admin]

input port is for sensor use, not for switch use. if you want to use switch, you need add "switch terminal board", it will work perfectly.
here is link: https://www.kincony.com/button-switch-mo...oller.html
RELAY-KEY.... command is feedback, when use switch terminal board for manual control. if add the switch terminal board, will support use by wireless remoter.